Honeywell MX7 Tecton - Commands Supported by Launch

9 - 6
Commands Supported by Launch
The commands supported by Launch are detailed below. Square brackets indicate that a parameter is optional. Characters
in italics represent a variable, and not a literal.
Copy
Delete
DelRegData
Copy
ElseIfFile IfFile Mkdir
Delete
EndIf IfTerm Rmdir
DelRegData
EndIfFile Launch SetRegData
DelRegKey
EndIfTerm LaunchCmd SetRegKey
ElseIf
FCopy Message Shortcut
Description
Copies a file but does not overwrite an existing file.
Syntax
Copy,source-file,destination-file
Parameters
source-file: The file to be copied, including its path.
destination-file: The destination path and filename.
Example copy,\Storage Card\MyData.dat,\Temp\MyData.dat
Notes
If the destination file already exists, it is not overwritten, and no error is given.
If the source file is blank, a zero-byte file is created.
Description
Deletes the specified file.
Syntax
Delete,source-file
Parameter
source-file: The file to be deleted, including its path.
Example delete,\Temp\MyData.dat
Description
Deletes a specified registry data field.
Syntax
Delregdata,key,subkey,field
Parameter
key: The abbreviated major registry key where you want to delete a field. Can be one of:
• cr or hkcr (HKEY_CLASSES_ROOT)
• cu or hkcu (HKEY_CURRENT_USER)
• lm or hklm (HKEY_LOCAL_MACHINE).
The case of key does not matter.
subkey: The subkey that holds the field you want to delete.
field: The field that you want to delete.
Example delregdata,LM,Software\WidgetsPlc\OurApp,AppName
Notes
An error isn’t displayed if you specify a non-existent field, but is displayed if you specify a non-
existent key or subkey.