EasyManua.ls Logo

Honeywell MX7 Tecton - Battery

Honeywell MX7 Tecton
354 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5 - 33
Battery
This panel is used to view the status and percentage of power remaining in the MX7 Tecton main battery.
Jacked is shown in the Status box when the Main battery is receiving external power.
The main battery is charged/recharged when the MX7 Tecton is docked in a powered cradle or directly cabled to an exter-
nal power source.
The internal battery draws power from the Main battery to maintain a charge. The Super-cap battery voltage and percent-
age of power fluctuate continuously.
When there is no Main battery in the unit, the internal battery begins to discharge as it maintains RAM and other vital set-
tings. After a Main battery is installed, the internal battery begins to draw power from the Main battery again and is fully
recharged in five minutes or less.
Note: Frequent connection to an external power source, if feasible, is recommended to maintain main battery charge status
as the Super-cap battery cannot be recharged by a dead or missing main battery.

Table of Contents

Other manuals for Honeywell MX7 Tecton

Related product manuals