Honeywell MX7 Tecton - Page 204

9 - 8
EndIf
EndIfFile
EndIfTerm
FCopy
Description
Ends conditional command block begun with the previous IF command.
Syntax
EndIf
Parameter
None
Example
See IfFile (page 9-9).
Notes
Results are unpredictable if not paired properly with If... command.
Description
Ends conditional command block begun with the previous IF command.
Syntax
EndIfFile
Parameter
None
Example
See IfFile (page 9-9).
Notes
Results are unpredictable if not paired properly with IfFile command.
Description
Ends conditional command block executed only if the device type specified in IfTerm match-
es.
Syntax
EndIfTerm
Parameter
None
Example
See IfTerm (page 9-9).
Notes
Results are unpredictable if not paired properly with IfTerm command.
Description
Copies a file, overwriting any existing file.
Syntax
fcopy,source-file,destination-file
Parameters
source-file: The file to be copied, including its path
destination-file: The destination path and filename
Example fcopy,\Storage Card\MyData.dat,\Temp\MyData.dat
Notes
If the destination file already exists it is overwritten.
If the source file is blank, a zero-byte file is created.