NORMAL OPERATION
Part. No. 2400M2501_6 Touchpoint Pro
128 Technical Handbook
14.11.2 Channel Auto-Inhibits
Auto-inhibits may occur when a mV input channel has been configured but not yet calibrated, when a transmitter is signalling
Inhibit, or when an Inhibit delay time is running. Please refer to Ch.17 Potential Issues for further information.
Auto-inhibits cannot be cleared manually.
Figure 95. Inputs Screen with menu options
It is possible to have more than one inhibit condition active on a channel, and you have to resolve all inhibit
conditions before the inhibit can be cleared.
To Next Page
Loading...
