TECHNICAL SPECIFICATIONS
Part. No. 2400M2501_6 Touchpoint Pro
167 Technical Handbook
21.2.3 Zone 2 Division 2 Remote Wall Unit Enclosure without User Interface
This wall mounted enclosure is certified for use in hazardous areas / locations (Class 1 Div.2, Class 1 Zone 2, and Zone 2
[ATEX]). This enclosure can only be used as a remote unit due to its classification, and no User Interface option is available.
This unit is IP 66 Type 4 & 4x and can be installed indoors or outdoors in a Pollution Degree 4 environment, and can be
exposed to rain, snow and direct UV rays (sunlight).
WARNING
Do not open when a flammable gas atmosphere is present.
(Class 1 Div.2, Class 1 Zone 2, and Zone 2 [ATEX])
AVERTISSEMENT
Ne pas ouvrir l’équipement dans des atmosphères contenant des gaz inflammables.
(Classe 1 Div.2, Classe 1 Zone 2, et Zone 2 [ATEX])
WARNING: EXPLOSION HAZARD
Substitution of components may impair suitability for Class 1 Div.2, Class 1 Zone 2, and Zone 2 [ATEX] non-
incendive approval.
AVERTISSEMENT: RISQUE D’EXPLOSION
Substituer des composants peut compromettre la conformité de la Classe 1 Div.2, Classe 1 Zone 2, et de la Zone 2
[ATEX] pour l’approbation de produits non inflammables.
Do not disconnect terminals or remove modules when energised.
(Class 1 Div.2, Class 1 Zone 2, and Zone 2 [ATEX])
AVERTISSEMENT
Ne pas déconnecter les terminaux ou supprimer les modules lorsque l’appareil est sous tension.
(Classe 1 Div.2, Classe 1 Zone 2, et Zone 2 [ATEX])
Wiring to and from this enclosure must utilise wiring methods suitable for Class 1 Div.2, Class 1 Zone 2, and Zone 2
[ATEX] Hazardous Locations as appropriate to the installation.
AVERTISSEMENT
Le câblage de ce boîtier doit respecter les méthodes d’installation appropriées en ce qui concerne les zones
dangereuses de la Classe 1 Div. 2, de la Classe 1 Zone 2 et de la Zone 2 [ATEX].
To Next Page
Loading...
Need help?
General
