Honeywell UMC800 - SPEV Function Block; Table 5-70 SPEV Dynamic Parameters

Function Parameter Index Reference
8/99 RS232 Communications Reference Manual 101
5.55 SPEV Function Block
Description
The SPEV label stands for Setpoint Programming Events. This block is part of the Setpoint Program
category. It looks like this graphically on the Control Builder.
Dynamic Parameters:
Table 5-70 SPEV Dynamic Parameters
Parameter Index Type Use R/W Description
status 0 REAL C R block status (see section 5.2 for code list)
E1 1 BOOL O R event 1
E2 2 BOOL O R event 2
E3 3 BOOL O R event 3
E4 4 BOOL O R event 4
E5 5 BOOL O R event 5
E6 6 BOOL O R event 6
E7 7 BOOL O R event 7
E8 8 BOOL O R event 8
E9 9 BOOL O R event 9