Honeywell UMC800 - LSEL Function Block; Table 5-39 LSEL Dynamic Parameters

Function Parameter Index Reference
8/99 RS232 Communications Reference Manual 73
5.31 LSEL Function Block
Description
The LSEL label stands for Low Selector. This block is part of the Signal Selectors category. It looks like
this graphically on the Control Builder.
Dynamic Parameters:
Table 5-39 LSEL Dynamic Parameters
Parameter Index Type Use R/W Description
status 0 REAL C R block status (see section 5.2 for code list)
OUT 1 REAL O R primary output
YHI(YLO) 2 BOOL O R override indication
X3REALIRinput
Y4REALIRinput
Static Configuration Parameters:
None