Honeywell UMC800 - ON;OFF Function Block; Table 5-54 ON;OFF Dynamic Parameters

Function Parameter Index Reference
8/99 RS232 Communications Reference Manual 85
5.43 ON/OFF Function Block
Description
The ON/OFF label stands for the On/Off Control function. This block is part of the Loops category. It
looks like this graphically on the Control Builder.
Dynamic Parameters:
Table 5-54 ON/OFF Dynamic Parameters
Parameter Index Type Use R/W Description
status 0 REAL C R block status (see section 5.2 for code list)
lsp 1 REAL C R/W local set point (eu)
lsp2 2 REAL C R/W local set point 2 (eu)
rem_mode 3 BOOL C R/W remote set point mode request {OFF, ON}
man_mode 4 BOOL C R/W manual output mode request {OFF, ON}
man_out 5 BOOL C R/W On/Off
rsp_eu 6 REAL C R remote set point in eu for monitoring
deviation 7 REAL C R Deviation in eu for monitoring
pv 8 REAL C R Process Variable in eu for monitoring
WSP 9 REAL O R Working Set Point in eu for monitoring
OUT 10 BOOL O R On/Off
MODE 11 REAL O R actual mode encoded
All 12 BOOL O R Alarm 1
AL2 13 BOOL O R Alarm 2
BCO 14 REAL O R Back Calculation Out (%)
PVI 15 REAL I R Process Variable Input (eu) (pv_lo <= PV <=
pv_hi)
RSP 16 REAL I R Remote Set Point (% or eu per sp_units)
TRV 17 BOOL I R On/Off
TRC 18 BOOL I R Manual On/Off