Honeywell UMC800 - Field calibration; Calibration procedures; AI module calibration

Function Parameter Index Reference
8/99 RS232 Communications Reference Manual 57
5.17 DCMP Function Block
Description
The DCMP label stands for Deviation Compare. This block is part of the Calculations category. It looks
like this graphically on the Control Builder.
Dynamic Parameters:
Table 5-21 DCMP
Dynamic Parameters
Parameter Index Type Use R/W Description
status 0 REAL C R block status (see section 5.2 for code list)
OUT 1 BOOL O R output
IN1 2 REAL I R input 1
IN2 3 REAL I R input 2
IN3 4 REAL I R input 3
IN4 5 REAL I R input 4
IN5 6 REAL I R input 5
IN6 7 REAL I R input 6
REF(Y) 8 REAL I R reference input
Static Configuration Parameters:
Table 5-22 DCMP Static Configuration Parameters
Parameter Index Type Description
+ DEV 0 REAL plus deviation
- DEV 1 REAL minus deviation