Honeywell UMC800 - HLLM Function Block; Table 5-33 HLLM Dynamic Parameters; Table 5-34 HLLM Static Configuration Parameters

Function Parameter Index Reference
68 RS232 Communications Reference Manual 8/99
5.26 HLLM Function Block
Description
The HLLM label stands for High Low Limiter. This block is part of the Auxiliary category. It looks like
this graphically on the Control Builder:
Dynamic Parameters:
Table 5-33 HLLM Dynamic Parameters
Parameter Index Type Use R/W Description
status 0 REAL C R block status (see section 5.2 for code list)
OUT 1 REAL O R primary output
H 2 BOOL O R high limit indication
L 3 BOOL O R low limit indication
X4REALIRinput
Static Configuration Parameters:
Table 5-34 HLLM Static Configuration Parameters
Parameter Index Type Description
hilim 0 REAL high limit {-99999 to 999999} for Analog X value
lolim 1 REAL low limit {-99999 to 999999} for Analog X value