Protocol Description
12 RS232 Communications Reference Manual 8/99
2.11 Application Error Codes
List of Codes
These codes are returned when ANAK is received in the response for a request that is rejected.
Table 2-1 Application Error Codes
Error Code Definition
0 No Errors
0x1 Bad Command
0x2 Bad Operation
0x4 Bad data for the Command
0x8 Not Used
0xA Busy Doing Command – Try Again Later
0x10 Invalid Header Byte
0x11 Bad Message Length
0x20 Bad Database Download Sequence
0x21 Invalid Database Table Number
0x22 Bad Record Number
0x23 Table Number Changed in the Middle of Download
0x24 Database Revision Level Mismatch
0x25 Bad Packet Size
0x26 Incomplete Record
0x27 SPP Database Table too big
0x30 Setpoint Program Segment Overrun
0x31 SPP – Invalid Mode for Editing (Not Reset or Hold)
To Next Page
Loading...
