Function Parameter Index Reference
8/99 RS232 Communications Reference Manual 117
5.64 SW Function Block
Description
The SW label stands for Analog Switch. This block is part of the Signal Selectors category. It looks like
this graphically on the Control Builder.
Dynamic Parameters:
Table 5-84 SW Dynamic Parameters
Parameter Index Type Use R/W Description
status 0 REAL C R block status (see section 5.2 for code list)
OUT 1 REAL O R output
X2REALIR
Y3REALIR
SY 4 BOOL I R select Y when ON
Static Configuration Parameters:
None
To Next Page
Loading...
