Honeywell UMC800 - Table 5-95 VLIM Dynamic Parameters; Table 5-96 VLIM Static Configuration Parameters; VLIM Function Block

Function Parameter Index Reference
8/99 RS232 Communications Reference Manual 127
5.72 VLIM Function Block
Description
The VLIM label stands for Velocity (Rate) Limiter. This block is part of the Auxiliary category. It looks
like this graphically on the Control Builder.
Dynamic Parameters:
Table 5-95 VLIM Dynamic Parameters
Parameter Index Type Use R/W Description
status 0 REAL C R block status (see section 5.2 for code list)
OUT 1 REAL O R primary output
H 2 BOOL O R high rate limit indication
L 3 BOOL O R low rate limit indication
X 4 REAL I R primary input
EN 5 BOOL I R enable input
Static Configuration Parameters:
Table 5-96 VLIM Static Configuration Parameters
Parameter Index Type Description
irate 0 REAL increase rate limit (eu/min, >=0) {0 to 99999}
drate 1 REAL decrease rate limit (eu/min, >=0) {0 to 99999}