Honeywell UMC800 - Table 5-89 TPO Dynamic Parameters; TPO Function Block

Function Parameter Index Reference
8/99 RS232 Communications Reference Manual 121
5.68 TPO Function Block
Description
The TPO label stands for Time Proportional Output. This block is part of the Loops category. It looks
like this graphically on the Control Builder.
Dynamic Parameters:
Table 5-89 TPO Dynamic Parameters
Parameter Index Type Use R/W Description
status 0 REAL C R block status (see section 5.2 for code list)
IN 1 REAL I R analog input value (usually %)
Static Configuration Parameters:
None