Function Parameter Index Reference
8/99 RS232 Communications Reference Manual 63
5.23 FGEN Function Block
Description
The FGEN label stands for Function Generator - 10 Segment. This block is part of the Auxiliary
category. It looks like this graphically on the Control Builder:
Dynamic Parameters:
Table 5-29 FGEN Dynamic Parameters
Parameter Index Type Use R/W Description
status 0 REAL C R block status (see section 5.2 for code list)
OUT 1 REAL O R output
X2REALIRinput
Static Configuration Parameters:
Table 5-30 FGEN Static Configuration Parameters
Parameter Index Type Description
xb[0] 0 REAL x breakpoint 1 (-99999 to 999999)
xb[1] 1 REAL x breakpoint 2 (-99999 to 999999)
xb[2] 2 REAL x breakpoint 3 (-99999 to 999999)
xb[3] 3 REAL x breakpoint 4 (-99999 to 999999)
xb[4] 4 REAL x breakpoint 5 (-99999 to 999999)
xb[5] 5 REAL x breakpoint 6 (-99999 to 999999)
xb[6] 6 REAL x breakpoint 7 (-99999 to 999999)
xb[7] 7 REAL x breakpoint 8 (-99999 to 999999)
xb[8] 8 REAL x breakpoint 9 (-99999 to 999999)
xb[9] 9 REAL x breakpoint 10 (-99999 to 999999)
xb[10] 10 REAL x breakpoint 11 (-99999 to 999999)
yb[0] 11 REAL output value at x breakpoint 1 (-99999 to 999999)
yb[1] 12 REAL output value at x breakpoint 2 (-99999 to 999999)
yb[2] 13 REAL output value at x breakpoint 3 (-99999 to 999999)
To Next Page
Loading...
