Honeywell UMC800 - ADD Function Block; Table 5-3 ADD Dynamic Parameters

Function Parameter Index Reference
8/99 RS232 Communications Reference Manual 39
5.3 ADD Function Block
Description
The ADD label stands for Addition Mathematical Operation (2 Inputs). This block is part of the Math
category. It looks like this graphically on the Control Builder.
X
Y
OUT
Dynamic Parameters:
Table 5-3 ADD Dynamic Parameters
Parameter Index Type Use R/W Description
status 0 REAL C R block status (see section 5.2 for code list)
OUT 1 REAL O R output
X 2 REAL I R input 1
Y 3 REAL I R input 2
Static Configuration Parameters: None