Function Parameter Index Reference
8/99 RS232 Communications Reference Manual 35
5. Function Parameter Index Reference
5.1 Parameter Index Numbers
Function Block parameter tables
Refer to the tables listed below to find the correct Dynamic (I/O) or Static (Configuration) parameter index
number for a given function block that is to be accessed through a communications message.
Abbreviations
The abbreviations used in the tables are:
REAL Floating Point Analog Numbers
BOOL Digital ON and OFF states
C Contained Parameter
I Input Value
O Output Value
R Read Only
R/W Read/Write
W Write
In this section
Refer to Table 4-1 for a listing of each function block type and respective reference page.
Table 5-1 Function Block Look-up Table
Function Block Type Identification Label See Subsection
ABS (Absolute Value)
5.2
ADD (Addition 2 Inputs)
5.3
4ADD (Addition 4 Inputs)
5.4
AI (Analog Input)
5.5
ALM (Analog Alarm)
5.6
2AND (AND - 2 Inputs)
5.7
4AND (AND - 4 Inputs)
5.8
8AND (AND - 8 Inputs)
5.9
AMB (Auto/Manual Bias)
5.10
AO (Analog Output)
5.11
ASYS (Alarm System Monitor)
5.12
BCD (Binary Coded Decimal Translator)
5.13
BOOL (Free Form Logic)
5.14
CARB (Carbon Potential)
5.15
CMPR (Comparison)
5.16
DCMP (Deviation Compare)
5.17
To Next Page
Loading...
