Honeywell UMC800 - TAHD Function Block; Table 5-85 TAHD Dynamic Parameters

Function Parameter Index Reference
118 RS232 Communications Reference Manual 8/99
5.65 TAHD Function Block
Description
The TAHD label stands for Track and Hold. This block is part of the Auxiliary category. It looks like this
graphically on the Control Builder.
Dynamic Parameters:
Table 5-85 TAHD Dynamic Parameters
Parameter Index Type Use R/W Description
status 0 REAL C R block status (see section 5.2 for code list)
OUT 1 REAL O R output
X 2 REAL I R primary input
TC 3 BOOL I R track command
Static Configuration Parameters:
None