HP 1910 User Manual

328
Figure 295 Enabling DHCP
2. Configure a DHCP server group:
a. In the Server Group area, click Add.
b. On the page that appears, enter 1 for Server Group ID, and enter 10.1.1.1 for IP Address.
c. Click Apply.
Figure 296 Adding a DHCP server group
3. Enable the DHCP relay agent on VLAN-interface 1:
a. In the Interface Config field, click the icon for VLAN-interface 1.

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24