HP 1910 User Manual

77
4. Click Apply.
Table 13 Configuration items
Item Descri
p
tion
Port State
Enable or disable the port.
After you modify the operation parameters of a port, you might need to disable and then
enable the port to make the modifications take effect.
Speed
Set the transmission rate of the port:
• 10—10 Mbps.
• 100—100 Mbps.
• 1000—1000 Mbps.
• Auto—Autonegotiation.
• Auto 10—Autonegotiated to 10 Mbps.
• Auto 100—Autonegotiated to 100 Mbps.
• Auto 1000—Autonegotiated to 1000 Mbps.
• Auto 10 100—Autonegotiated to 10 or 100 Mbps.
• Auto 10 1000—Autonegotiated to 10 or 1000 Mbps.
• Auto 100 1000—Autonegotiated to 100 or 1000 Mbps.
• Auto 10 100 1000—Autonegotiated to 10, 100, or 1000 Mbps.
Duplex
Set the duplex mode of the port:
• Auto—Autonegotiation.
• Full—Full duplex.
• Half—Half duplex.
Link Type
Set the link type of the current port, which can be access, hybrid, or trunk. For more
information, see "Configuring VLANs."
To change the link type of a port from trunk to hybrid or vice versa, you must first set its link
type to access.
PVID
Set the default VLAN ID of the interface. For more information about setting the PVID, see
"Configuring VLANs."
To make sure a link correctly transmits packets, the trunk or hybrid ports at the two ends
of the link must have the same PVID.

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24