HPE Apollo 2000 User Manual

Hardware options installation 100
9.
If installed, remove the air scoop from the controller.
10. Open the latch on the controller.
11. Connect the cache module backup power cable to the module.
12. Install the cache module on the storage controller.
13. If you installed a cache module on the storage controller, connect the cache module backup power
cable to the riser board ("FBWC module cabling" on page 142).

HPE Apollo 2000 Specifications

General

Form Factor	2U
Memory Type	DDR4
Max Processors	2
Memory Slots	16 DIMM slots per server tray
Storage Options	SAS, SATA
Networking	FlexibleLOM
Network	1/10/25/40/100 GbE options
Power Supply	Redundant Power Supplies
Power Supply Options	1600W
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware
Storage	Up to 24 drives