Huawei quidway s7700 - Page 151

On the computer on the Layer 2 network connected to Switch B, set the default gateway address
to the IP address of VLANIF 10, that is, 20.20.20.1/24.
After the configurations are complete, computers of the two Layer 2 networks are isolated at
Layer 2 and interwork at Layer 3.
----End
Configuration Files
Configuration file of Switch A
#
sysname SwitchA
#
router id 1.1.1.1
#
vlan batch 10 30
#
interface Vlanif10
ip address 10.10.10.1 255.255.255.0
#
interface Vlanif30
ip address 30.30.30.1 255.255.255.0
#
interface GigabitEthernet1/0/1
port link-type trunk
port trunk allow-pass vlan 10
#
interface GigabitEthernet1/0/2
port link-type trunk
port trunk allow-pass vlan 30
#
ospf 1
area 0.0.0.0
network 10.10.10.0 0.0.0.255
network 30.30.30.0 0.0.0.255
#
return
Configuration file of Switch B
#
sysname SwitchB
#
router id 2.2.2.2
#
vlan batch 10 30
#
interface Vlanif10
ip address 20.20.20.1 255.255.255.0
#
interface Vlanif30
ip address 30.30.30.2 255.255.255.0
#
interface GigabitEthernet1/0/1
port link-type trunk
port trunk allow-pass vlan 30
#
interface GigabitEthernet1/0/2
port link-type trunk
port trunk allow-pass vlan 10
#
ospf 1
area 0.0.0.0
network 20.20.20.0 0.0.0.255
network 30.30.30.0 0.0.0.255
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 3 VLAN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
134