Take the display on PE1 as an example.
<PE1> display mpls ldp session
LDP Session(s) in Public Network
------------------------------------------------------------------------------
Peer-ID Status LAM SsnRole SsnAge KA-Sent/Rcv
------------------------------------------------------------------------------
2.2.2.9:0 Operational DU Passive 000:15:29 3717/3717
3.3.3.9:0 Operational DU Passive 000:00:00 2/2
------------------------------------------------------------------------------
TOTAL: 2 session(s) Found.
LAM : Label Advertisement Mode SsnAge Unit : DDD:HH:MM
Step 6 Enable MPLS L2VPN on the PEs and create VC connections.
# Configure PE1: Create a VC connection on GigabitEthernet 1/0/0.1 that is connected to CE1.
[PE1] mpls l2vpn
[PE1-l2vpn] mpls l2vpn default martini
[PE1-l2vpn] quit
[PE1] interface gigabitethernet 1/0/0.1
[PE1-GigabitEthernet1/0/0.1] qinq mapping pe-vid 100 ce-vid 10 map-vlan vid 200
[PE1-GigabitEthernet1/0/0.1] mpls l2vc 3.3.3.9 101
[PE1-GigabitEthernet1/0/0.1] quit
# Configure PE2, create a VC connection on GigabitEthernet 2/0/0.1 that is connected to CE1.
[PE2] mpls l2vpn
[PE2-l2vpn] mpls l2vpn default martini
[PE2-l2vpn] quit
[PE2] interface gigabitethernet 2/0/0.1
[PE2-GigabitEthernet2/0/0.1] control-vid 2000 qinq-termination
[PE2-GigabitEthernet2/0/0.1] qinq termination pe-vid 200 ce-vid 10
[PE2-GigabitEthernet2/0/0.1] mpls l2vc 1.1.1.9 101
[PE2-GigabitEthernet2/0/0.1] quit
Step 7 Verify the configuration.
On PEs, check the L2VPN connections. You can see that an L2VC connection is set up and is
in Up state.
Take the display on PE1 as an example.
<PE1> display mpls l2vc interface gigabitethernet 1/0/0.1
*client interface : gigabitethernet 1/0/0.1 is up
session state : up
AC state : up
VC state : up
VC ID : 101
VC type : VLAN
destination : 3.3.3.9
local group ID : 0 remote group ID : 0
local VC label : 21504 remote VC label : 21504
local AC OAM State : up
local PSN State : up
local forwarding state : forwarding
BFD for PW : unavailable
manual fault : not set
active state : active
forwarding entry : not exist
link state : up
local VC MTU : 1500 remote VC MTU : 1500
local VCCV : Disable
remote VCCV : none
local control word : disable remote control word : none
tunnel policy name : --
traffic behavior name : --
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 5 QinQ Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
255
To Next Page
Loading...
