IAI SEL User Manual

* Supplement
292
232
Press the ESC key several times to move to the Flash ROM writing screen.
Write the data to Flash ROM.
Press the F1 (Yes) key.
Execute restart (software reset).
Press the F1 (Yes) key.
(3) Execute an absolute reset according to the following special procedure (forced operation by
ignoring the screen steps):
Mode Transition:
① Execute the “encoder multi-rotation data reset 1“ for the slave axis.
Input the axis No. of the slave axis and press the
return key.
Press the F1 (OK) key.
Press the F1 (OK) key.
Exit from the absolute reset mode temporarily with
the ESC key, without pressing the F1 (OK) key.

IAI SEL Specifications

General

Protection Class	IP20
Communication	RS-232C
Control Method	PTP
Number of Axes	Up to 4 axes
Vibration Resistance	4.9 m/s² (0.5 G)
Humidity	20 to 85% RH (non-condensing)