Parameters
Parameter Description
logicaldrive or logicaldrives The name of the FlashCopy logical drive that you want
to delete. You can enter more than one FlashCopy logical
drive name. Enclose the FlashCopy logical drive name in
square brackets ([ ]). If the FlashCopy logical drive name
has special characters, you also must enclose the
FlashCopy logical drive name in double quotation marks
(" ").
schedule This parameter deletes the schedule for a specific
FlashCopy logical drive. Only the schedule is deleted,
the FlashCopy logical drive remains.
Delete Host
This command deletes a host.
Syntax
delete host [hostName]
Delete Host Group
This command deletes a host group.
Attention: Possible damage to the storage subsystem configuration – This command deletes all of the
host definitions in the host group.
Syntax
delete hostGroup [hostGroupName]
Parameter
Parameter Description
hostGroup The name of the host group that you want to delete.
Enclose the host group name in square brackets ([ ]). If the
host group name has special characters, you also must
enclose the host group name in double quotation marks
(“ ”).
Notes
A host group is an optional topological element that is a collection of hosts that share access to the same
logical drives. The host group is a logical entity.
Delete Host Port
This command deletes an HBA host port identification. The identification is a software value that
represents the physical HBA host port to the controller. By deleting the identification, the controller no
longer recognizes instructions and data from the HBA host port.
Chapter 3. Script Commands 3-115
To Next Page
Loading...
Need help?
General