Minimum Firmware Level
7.84
Show Array
This command returns this information about a Array:
v The status (Online or Offline)
v The drive type (Fibre Channel, SATA, or SAS)
v Enclosure loss protection (yes or no)
v The current owner (the controller in slot A or the controller in slot B)
v The associated volumes and free capacity
v The associated drives
Syntax
show volumeGroup [volumeGroupName]
Parameter
Parameter Description
volumeGroup The alphanumeric identifier of the Array (including - and
_) for which you want to show information. Enclose the
Array identifier in square brackets ([ ]).
Notes
This command returns Array information as shown in this example:
Array 1 (RAID 5)
Status: Online
Drive type: Fibre Channel
Enclosure loss protection: No
Current owner: Controller in slot A
Associated volumes and free capacities:
1 (1 GB), 1R1 (0.2 GB), Free Capacity (134.533 GB)
Associated drives (in piece order):
Drive at Enclosure 1, Slot 14
Drive at Enclosure 1, Slot 13
Drive at Enclosure 1, Slot 12
Minimum Firmware Level
6.10
Show array export dependencies
This command shows a list of dependencies for the drives in an array that you want to move from one
storage subsystem to a second storage subsystem.
Syntax
show array [arrayName] exportDependencies
Chapter 3. Script Commands 3-267
To Next Page
Loading...
Need help?
General