Stop Pending Enhanced FlashCopy Images on Consistency Group
This command stops all of the pending Enhanced FlashCopy images that are to be created on an
Enhanced FlashCopy consistency group. If the Enhanced FlashCopy consistency group does not have any
pending Enhanced FlashCopy images, the storage management software displays an error message and
does not run the command.
Syntax
stop consistencyGroup [consistencyGroupName] pendingEnhancedFlashCopyImageCreation
Parameters
Parameter Description
consistencyGroupName The name of the consistency group for which you want
to stop any pending Enhanced FlashCopy operation.
Enclose the name of the consistency group in square
brackets ([ ]).
Stop Storage Subsystem Drive Firmware Download
This command stops a firmware download to the disk drives in a storage subsystem that was started
with the download storageSubsystem driveFirmware command. This command does not stop a firmware
download that is already in progress to a disk drive. This command stops all firmware downloads to disk
drives that are waiting for the download.
Syntax
stop storageSubsystem driveFirmwareDownload
Parameters
None.
Stop Storage Subsystem Locate
This command turns off the indicator lights on the storage subsystem that were turned on by the start
storageSubsystem locate command.
Syntax
stop storageSubsystem locate
Parameters
None.
Stop VolumeCopy
This command stops a VolumeCopy operation.
Syntax
stop VolumeCopy target [targetName] source [sourceName]
Chapter 3. Script Commands 3-317