IBM System Storage DS3000 User Manual

Parameters
Parameter Description
controller The controller that has the host interface card on which you
are running the diagnostic tests. Valid controller identifiers
are a or b, where a is the controller in slot A, and b is the
controller in slot B. Enclose the controller identifier in square
brackets ([ ]). If you do not specify a controller, the storage
management software returns a syntax error.
progressOnly The progressOnly parameter, shows the progress of the
diagnostic test without waiting for the diagnostic tests to
completely finish.
file The name of the file that contains the results of the
diagnostic tests. This command does not automatically
append a file extension to the file name. You must add an
extension when you enter the file name.
Note: The progressOnly parameter is useful for seeing the progress of command scripts that need to
sequentially complete operations.
Show Host Ports
For all of the HBA host ports that are connected to a storage subsystem, this command returns this
information:
v The HBA host port identifier
v The HBA host port name
v The HBA host type
Syntax
show allHostPorts
Parameters
None.
Notes
This command returns HBA host port information similar to this example:
HOST PORT IDENTIFIER HOST PORT NAME HOST TYPE
12:34:56:54:33:22:22:22 Jupiter1 Solaris
12:34:56:78:98:98:88:88 Pluto1 Windows 2000/Server 2003 Clustered
54:32:12:34:34:55:65:66 Undefined Undefined
Show Logical Drive
For the logical drives in a storage subsystem, this command returns the following information:
v The number of logical drives
v The name
v The status
v The capacity
v The RAID level
v The subsystem where the logical drive is located
3-264 IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide

IBM System Storage DS3000 Specifications

General

Brand	IBM
Model	System Storage DS3000
Category	Storage
Language	English