IBM System Storage DS3000 User Manual

Parameter
Parameter Description
array The alphanumeric identifier (including - and _) of the
array for which you want to show export dependencies.
Enclose the array identifier in square brackets ([ ]).
Notes
This command spins up the drives in a array, reads the DACstore, and shows a list of import
dependencies for the Array. The Array must be in an Exported state or a Forced state.
Minimum Firmware Level
7.10
Show Array import dependencies
This command shows a list of dependencies for the drives in a Array that you want to move from one
storage subsystem to a second storage subsystem.
Syntax
show volumeGroup [volumeGroupName] importDependencies
[cancelImport=(TRUE | FALSE)]
Parameters
Parameter Description
volumeGroup The alphanumeric identifier (including - and _) of the
Array for which you want to show import dependencies.
Enclose the Array identifier in square brackets ([ ]).
cancelImport The setting to spin the drives back down after the Array
dependencies have been read. To spin down the drives,
set this parameter to TRUE. To let the drives stay
spinning, set this parameter to FALSE.
Notes
This command returns the dependencies of a specific Array, which must be in an Exported state or a
Forced state. If a decision is made to retain the listed dependencies, then the cancelImport parameter can
be enforced to spin the drives back down.
You must run the show volumeGroup importDependencies command before you run the start
volumeGroup import command.
Minimum Firmware Level
7.10
3-268 IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide

IBM System Storage DS3000 Specifications

General

Brand	IBM
Model	System Storage DS3000
Category	Storage
Language	English