Parameters
Parameter Description
enhancedFlashCopyLogicalDrive The name of the Enhanced FlashCopy logical drive that
you want to rename. Enclose the Enhanced FlashCopy
logical drive name in double quotation marks (" ") inside
of square brackets ([ ]).
userLabel A new name that you want to give to the Enhanced
FlashCopy logical drive. Enclose the new Enhanced
FlashCopy logical drive name in double quotation marks
(" ").
Notes
You can use any combination of alphanumeric characters, underscore (_), hyphen (-), and pound (#) for
the names. Names can have a maximum of 30 characters.
Rename Performance Read Cache
This command changes the name of the Performance Read Cache.
Syntax
set performanceReadCache [old_performanceReadCacheName]
userLabel="new_performanceReadCacheName"
Parameters
Parameter Description
performanceReadCache The alphanumeric identifier (including - and _) of the
Performance Read Cache that you want to rename.
Enclose the identifier in square brackets ([ ]). If the
Performance Read Cache name contains special
characters or consists only of numbers, you also must
enclose the identifier in double quotation marks (" ")
inside square brackets.
userLabel The new name for the Performance Read Cache. Enclose
the name in double quotation marks (" ").You can use
any combination of alphanumeric characters, underscore
(_), hyphen (-), and pound (#) for the identifier.
Identifiers can have a maximum of 30 characters.
Minimum Firmware Level
7.84
Repair Logical Drive Parity
This command repairs the parity errors on a logical drive.
Chapter 3. Script Commands 3-155