IBM System Storage DS3000 User Manual

Syntax
start drive [enclosureID,drawerID,slotID] initialize
Parameter
Parameter Description
drive EnclosureID1,drawerID1,slotID1 ...
enclosureIDn,drawerIDn,slotIDn is for enclosures with
multiple disk drive drawers. For enclosures without disk
drive drawers, use enclosureID1,slotID1 ...
enclosureIDn,slotIDn instead. Enclosure ID values are 0 to
99. Drawer ID values are 1 to 5. Slot ID values are 1 to 32.
Enclose the values in square brackets ([ ]).
Notes
The drive parameter supports both high-capacity drive expansion enclosures and low-capacity drive
expansion enclosures. A high-capacity drive expansion enclosure has drawers that hold the drives. The
drawers slide out of the drive expansion enclosure to provide access to the drives. A low-capacity drive
expansion enclosure does not have drawers. For a high-capacity drive expansion enclosure, you must
specify the identifier (ID) of the drive expansion enclosure, the ID of the drawer, and the ID of the slot in
which a drive resides. For a low-capacity drive expansion enclosure, you need only specify the ID of the
drive expansion enclosure and the ID of the slot in which a drive resides. For a low-capacity drive
expansion enclosure, an alternative method for identifying a location for a drive is to specify the ID of
the drive expansion enclosure, set the ID of the drawer to 0, and specify the ID of the slot in which a
drive resides.
Start Drive Locate
This command locates a disk drive by turning on an indicator light on the disk drive. (Run the stop
drive locate command to turn off the indicator light on the disk drive.)
Syntax
start drive [enclosureID,drawerID,slotID] locate
Parameter
Parameter Description
drive EnclosureID1,drawerID1,slotID1 ...
enclosureIDn,drawerIDn,slotIDn is for enclosures with
multiple disk drive drawers. For enclosures without
disk drive drawers, use enclosureID1,slotID1 ...
enclosureIDn,slotIDn instead. Enclosure ID values are 0
to 99. Drawer ID values are 1 to 5. Slot ID values are 1
to 32. Enclose the values in square brackets ([ ]).
Notes
The drive parameter supports both high-capacity drive expansion enclosures and lowcapacity drive
expansion enclosures. A high-capacity drive expansion enclosure has drawers that hold the drives. The
drawers slide out of the drive expansion enclosure to provide access to the drives. A lowcapacity drive
expansion enclosure does not have drawers. For a high-capacity drive expansion enclosure, you must
specify the identifier (ID) of the drive expansion enclosure, the ID of the drawer, and the ID of the slot in
which a drive resides. For a lowcapacity drive expansion enclosure, you need only specify the ID of the
3-294 IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide

IBM System Storage DS3000 Specifications

General

Brand	IBM
Model	System Storage DS3000
Category	Storage
Language	English