IBM System Storage DS3000

Disk Drive Commands
“Download Drive Firmware” on page 3-125
“Replace Disk Drive” on page 3-156
“Revive Disk Drive” on page 3-168
“Save Disk Drive Channel Fault Isolation Diagnostic Status” on page 3-173
“Save Drive Log” on page 3-173
“Set Disk Drive Hot Spare” on page 3-199
“Set Disk Drive Service Action Allowed Indicator” on page 3-200
“Set Drive State” on page 3-200
“Set Foreign Disk Drive to Native” on page 3-211
“Show Disk Drive” on page 3-256
“Show Drive Download Progress” on page 3-258
“Start Drive Channel Fault Isolation Diagnostics” on page 3-292
“Start Disk Drive Initialize” on page 3-293
“Start Drive Locate” on page 3-294
“Start Disk Drive Reconstruction” on page 3-295
“Start Secure Disk Drive Erase” on page 3-302
“Start Drive Channel Locate” on page 3-293
“Stop Drive Channel Fault Isolation Diagnostics” on page 3-309
“Stop Drive Locate” on page 3-310
Enclosure Commands
“Download Enclosure Configuration Settings” on page 3-126
“Download Environmental Card Firmware” on page 3-127
“Save Enclosure Log” on page 3-174
“Set Enclosure Alarm” on page 3-201
“Set Enclosure Identification” on page 3-202
“Set Enclosure Service Action Allowed Indicator” on page 3-202
“Start Enclosure Locate” on page 3-295
3-326 IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide