Thin logicalDrive name: logicalDrive-nameRepository logicalDrive Name: REPOS_NNNN
Logged Time Expansion Type Start Capacity End Capacity
MM/DD/YYYY HH:MM:SS Manual|Automatic NNNNNNNN bytes NNNNNNNN bytes
With the consumedCapacity parameter, the command returns information similar to the example shown
below:
Logical Drive Provisioned Capacity Consumed Capacity Quota % Prov. Consumed
logicaldriveName 500.000 GB 230.000 GB 700.000 GB 46%
Show Storage Subsystem Unconfigured iSCSI Initiators
This command returns a list of initiators that have been detected by the storage subsystem but are not yet
configured into the storage subsystem topology.
Syntax
show storageSubsystem unconfiguredIscsiInitiators
Parameters
None.
Show VolumeCopy
This command returns this information about VolumeCopy operations:
v The copy status
v The start time stamp
v The completion time stamp
v The copy priority
v The source logical drive World-Wide Identifier (WWID) or the target logical drive WWID
v The target logical drive Read-Only attribute setting
You can retrieve information about a specific VolumeCopy pair or all of the VolumeCopy pairs in the
storage subsystem.
Syntax
show VolumeCopy (allLogicalDrives | source [“sourceName”] |
target [“targetName”])
Parameters
Parameter Description
allLogicalDrives The setting to return information about VolumeCopy
operations for all of the VolumeCopy pairs.
source The name of the source logical drive about which you
want to retrieve information. Enclose the source logical
drive name in double quotation marks (“ ”) inside of
square brackets ([ ]).
Chapter 3. Script Commands 3-281
To Next Page
Loading...
Need help?
General