EasyManuals Logo

IBM System Storage DS3000 User Manual

IBM System Storage DS3000
652 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #257 background imageLoading...
Page #257 background image
Parameters
Parameter Description
logicalDrive or logicalDrives The name of the specific FlashCopy logical drive
for which you want to define properties. (You
can enter more than one logical drive name if
you use the logicalDrives parameter). Enclose
the FlashCopy logical drive name in double
quotation marks (“ ”) inside of square brackets
([ ]).
userLabel A new name that you want to give to a
FlashCopy logical drive. Enclose the new
FlashCopy logical drive name in double
quotation marks (“ ”).
warningThresholdPercent The percentage of repository capacity at which
you receive a warning that the FlashCopy
repository is nearing full. Use integer values. For
example, a value of 70 means 70 percent. The
default value is 50.
repositoryFullPolicy How you want FlashCopy processing to continue
if the FlashCopy repository logical drive is full.
You can choose to fail writes to the base logical
drive (failBaseWrites) or fail writes to the
FlashCopy logical drive (failFlashCopy). The
default value is failFlashCopy.
Notes
When you use this command, you can specify one or more of the optional parameters.
You can use any combination of alphanumeric characters, hyphens, and underscores for the names.
Names can have a maximum of 30 characters.
You can set the warningThresholdPercent parameter and the repositoryFullPolicy parameter for both
the FlashCopy repository logical drive or the FlashCopy logical drive.
Set Foreign Disk Drive to Native
A drive is considered to be native when it is a part of the storage subsystem's subsystem configuration. A
drive is considered to be foreign when it does not belong to the storage subsystem's subsystem
configuration or when it fails to be imported with the drives of an subsystem that is transferred to a new
storage subsystem. The latter failure creates an incomplete subsystem on the new storage subsystem.
Run this command to add the missing (foreign) drives back into their original subsystem and to make
them part of the new storage subsystem subsystem configuration of the new storage subsystem.
Use this operation for emergency recovery only: when one or more drives need to be changed from a
foreign drive status and returned to a native status within their original subsystem.
Attention: Possible data corruption or data loss—Using this command for reasons other than what is
stated previously might result in data loss without notification.
Syntax
set (drive [enclosureID1,drawerID1,slotID1 ... enclosureIDn,drawerIDn,slotIDn]|
allDrives) nativeState
Chapter 3. Script Commands 3-211

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM System Storage DS3000 and is the answer not in the manual?

IBM System Storage DS3000 Specifications

General IconGeneral
BrandIBM
ModelSystem Storage DS3000
CategoryStorage
LanguageEnglish

Related product manuals