IBM System Storage DS3000 User Manual

Parameters
Parameter Description
drive EnclosureID1,drawerID1,slotID1 ...
enclosureIDn,drawerIDn,slotIDn is for enclosures with
multiple disk drive drawers. For enclosures without disk
drive drawers, use enclosureID1,slotID1 ...
enclosureIDn,slotIDn instead. Enclosure ID values are 0 to 99.
Drawer ID values are 1 to 5. Slot ID values are 1 to 32.
Enclose the values in square brackets ([ ]).
allDrives The setting to select all of the drives.
Notes
The drive parameter supports both high-capacity drive expansion enclosures and low-capacity drive
expansion enclosures. A high-capacity drive expansion enclosure has drawers that hold the drives. The
drawers slide out of the drive expansion enclosure to provide access to the drives. A low-capacity drive
expansion enclosure does not have drawers. For a high-capacity drive expansion enclosure, you must
specify the identifier (ID) of the drive expansion enclosure, the ID of the drawer, and the ID of the slot in
which a drive resides. For a low-capacity drive expansion enclosure, you need only specify the ID of the
drive expansion enclosure and the ID of the slot in which a drive resides. For a low-capacity drive
expansion enclosure, an alternative method for identifying a location for a drive is to specify the ID of
the drive expansion enclosure, set the ID of the drawer to 0, and specify the ID of the slot in which a
drive resides.
Set Host
This command assigns a host to a host group or moves a host to a different host group. You can also
create a new host group and assign the host to the new host group with this command. The actions
performed by this command depend on whether the host has individual Volume-to-LUN mappings or
does not have individual Volume-to-LUN mappings.
Syntax
set host [hostName]
hostGroup=(“hostGroupName” | none | defaultGroup)
userLabel=“newHostName”
hostType=(hostTypeIndexLabel | hostTypeIndexNumber)
Parameters
Parameter Description
host The name of the host that you want to assign to a host group. Enclose
the host name in square brackets ([ ]). If the host name has special
characters, you also must enclose the host name in double quotation
marks (“ ”).
hostGroup The name of the host group to which you want to assign the host.
(The following table defines how the command runs if the host does
or does not have individual logical drive-to-LUN mappings.) Enclose
the host group name in double quotation marks (“ ”). The
defaultGroup option is the host group that contains the host to which
the logical drive is mapped.
userLabel The new host name. Enclose the host name in double quotation marks
(“ ”).
3-212 IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide

IBM System Storage DS3000 Specifications

General

Brand	IBM
Model	System Storage DS3000
Category	Storage
Language	English