Minimum Firmware Level
7.10
Start Array locate
This command identifies the drives that are logically grouped together to form the specified Array by
flashing the indicator lights on the drives. (Use the stop volumeGroup locate command to turn off the
indicator lights on the drives.)
Syntax
start volumeGroup [volumeGroupName] locate
Parameter
Parameter Description
volumeGroup The alphanumeric identifier of the Array (including - and
_) for which you want to locate the drives that belong to
that Array. Enclose the Array identifier in square brackets
([ ]).
Minimum Firmware Level
6.16
Start Logical Drive Initialization
This command starts the formatting of a logical drive in a storage subsystem.
Note: Formatting a logical drive starts a long-running operation that you cannot stop.
Syntax
start logicalDrive [logicalDriveName] initialize
Parameter
Parameter Description
logicalDrive The name of the logical drive for which you are starting the
formatting. Enclose the logical drive name in square brackets
([ ]). If the logical drive name has special characters, you also
must enclose the logical drive name in double quotation
marks (“ ”).
Start Secure Disk Drive Erase
This command erases all of the data from one or more Full Disk Encryption (FDE) drives so that they can
be reused as FDE drives. Run this command only when the FDE drives are no longer part of a secure
subsystem, or when the security key is unknown.
3-302 IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide
To Next Page
Loading...
Need help?
General