Parameter
Parameter Description
enclosurePositions A list of all of the enclosure IDs. The sequence of the
enclosure IDs in the list defines the positions for the
controller module and the expansion drawers in a
storage subsystem. Valid values are 0 to 99. Enter the
enclosure ID values separated by a space. Enclose the
list of enclosure ID values in parentheses. For storage
subsystems where the controller module has a
predefined identifier that is not in the range of valid
enclosure position values, use the controller value.
Notes
This command defines the position of a enclosure in a storage subsystem by the position of the enclosure
ID in the enclosurePositions list. For example, if you have a controller module with an ID set to 84 and
expansion drawers with IDs set to 1, 12, and 50, the enclosurePositions sequence (8411250) places the
controller module in the first position, expansion drawer 1 in the second position, expansion drawer 12 in
the third position, and expansion drawer 50 in the fourth position. The enclosurePositions sequence (1
84 50 12) places the controller module in the second position, expansion drawer 1 in the first position,
expansion drawer 50 in the third position, and expansion drawer 12 in the fourth position.
You must include all of the enclosures in the storage subsystem in the list defined by the
enclosurePositions parameter. If the number of enclosures in the list does not match the total number of
enclosures in the storage subsystem, an error message appears.
Set Storage Subsystem ICMP Response
This command returns the default values for negotiable settings for sessions and connections, which
represent the starting point for the storage subsystem for negotiations.
Syntax
set storageSubsystem icmpPingResponse=(TRUE | FALSE)
Parameter
Parameter Description
icmpPingResponse This parameter turns on or turns off Echo
Request messages. Set the parameter to TRUE
to turn on Echo Request messages. Set the
parameter to FALSE to turn off Echo Request
messages.
Notes
The Internet Control Message Protocol (ICMP) is used by operating systems in a network to send error
messages, test packets, and informational messages related to the IP, such as a requested service is not
available or that a host or router could not be reached. The ICMP response command sends ICMP Echo
Request messages and receives Echo Response messages to determine if a host is reachable and how long
packets take to get to and from that host.
Chapter 3. Script Commands 3-239
To Next Page
Loading...
Need help?
General