To Next Page

To Previous Page

Parameter

Parameter Description

iscsi-host-port The identifier of the port on the storage subsystem on

which you want to refresh the DHCP parameters. Enclose

the iSCSI host port name in square brackets ([ ]).

Notes

This operation ends the iSCSI connections for the portal and brings down the portal temporarily.

Start Array defragment

This command starts a defragment operation on the specified Array.

NOTE Defragmenting a Array starts a long-running operation that you cannot stop.

Syntax

start volumeGroup [volumeGroupName] defragment

Parameter

Parameter Description

volumeGroup The alphanumeric identifier of the Array (including - and

_) that you want to defragment. Enclose the volume

group identifier in square brackets ([ ]).

Notes

Host I/O errors might result in the Arrays with more than 32 volumes. This operation also might result

in internal controller reboots because the timeout period ends before the Array definition is set. If you

experience this issue, quiesce the host I/O operations, and try the command again.

Minimum Firmware Level

6.10

Start Array export

This command moves a Array into an Exported state. Then you can remove the drives that comprise the

Array and reinstall the drives in a different storage subsystem.

NOTE Within the Array, you cannot move volumes that are associated with the premium features from

one storage subsystem to another storage subsystem.

Syntax

start volumeGroup [volumeGroupName] export

3-300 IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide

IBM System Storage DS3000 User Manual

Questions and Answers: