Parameter
Parameter Description
drive The location of the drive that you want to revive. For
high-capacity disk drive expansion enclosures, specify the
enclosure ID value, the drawer ID value, and the slot ID
value for the disk drive. For low-capacity drive expansion
enclosures, specify the enclosure ID value and the slot ID
value for the disk drive. Enclosure ID values are 0 to 99.
Drawer ID values are 1 to 5. Slot ID values are 1 to 32.
Enclose the enclosure ID value, the drawer ID value, and
the slot ID value in square brackets ([ ]).
Notes
The drive parameter supports both high-capacity drive expansion enclosures and low-capacity drive
expansion enclosures. A high-capacity drive expansion enclosure has drawers that hold the drives. The
drawers slide out of the drive expansion enclosure to provide access to the drives. A low-capacity drive
expansion enclosure does not have drawers. For a high-capacity drive expansion enclosure, you must
specify the identifier (ID) of the drive expansion enclosure, the ID of the drawer, and the ID of the slot in
which a drive resides. For a low-capacity drive expansion enclosure, you need only specify the ID of the
drive expansion enclosure and the ID of the slot in which a drive resides. For a low-capacity drive
expansion enclosure, an alternative method for identifying a location for a drive is to specify the ID of
the drive expansion enclosure, set the ID of the drawer to 0, and specify the ID of the slot in which a
drive resides.
Revive Enhanced FlashCopy Group
This command forces the specified Enhanced FlashCopy group to the Optimal state. If the Enhanced
FlashCopy group is not in a Failed state, the firmware displays an error message and does not run this
command.
Syntax
revive enhancedFlashCopyGroup [enhancedFlashCopyGroupName]
Parameters
Parameter Description
enhancedFlashCopyGroup The alphanumeric identifier (including - and _) of the
Enhanced FlashCopy group that you want to set to the
Optimal state. Enclose the Enhanced FlashCopy group
identifier in square brackets ([ ]).
Revive Enhanced FlashCopy Logical Drive
This command forces a specified Enhanced FlashCopy logical drive to the Optimal state. The Enhanced
FlashCopy logical drive can be one of these:
v A standalone Enhanced FlashCopy logical drive
v An Enhanced FlashCopy logical drive that is a member of a consistency group
If the Enhanced FlashCopy logical drive is not in a Failed state, the firmware displays an error message
and does not run this command.
Chapter 3. Script Commands 3-169
To Next Page
Loading...
Need help?
General