IBM System Storage DS3000 User Manual

Parameter
Parameter Description
performanceReadCache The alphanumeric identifier (including - and _) of the
Performance Read Cache that you want to resume.
Enclose the identifier in square brackets ([ ]). If the
Performance Read Cache name contains special
characters or consists only of numbers, you also must
enclose the identifier in double quotation marks (" ")
inside square brackets.
Minimum Firmware Level
7.84
Revive array
This command forces the specified array and its associated failed disk drives to the Optimal state.
Attention: Possible loss of data access or data integrity issues – Correct use of this command depends
on the data configuration on all of the disk drives in the array. Never try to revive a disk drive unless
you are supervised by an IBM Technical Support representative.
Syntax
revive array [arrayName]
Parameter
Parameter Description
subsystem The alphanumeric identifier (including - and _) of the array
to be set to the Optimal state. Enclose the array identifier in
square brackets ([ ]).
Revive Disk Drive
This command forces the specified disk drive to the Optimal state.
Attention: Possible loss of data access or possible data integrity issues – Correct use of this command
depends on the data configuration on all of the disk drives in the subsystem. Never try to revive a disk
drive unless you are supervised by an IBM Technical Support representative.
Syntax
revive drive [enclosureID,drawerID,slotID]
3-168 IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide

IBM System Storage DS3000 Specifications

General

Brand	IBM
Model	System Storage DS3000
Category	Storage
Language	English