Chapter 14. Deprecated Commands and Parameters
This appendix lists the commands, command formats, and parameters that are no longer supported by
this level of software. The information is presented in two tables. “Deprecated Commands” lists
commands no longer supported in this level of software and the new commands that replaced them.
“Deprecated Parameters” lists the parameters no longer supported in this level of software and the new
parameters that replaced them.
Deprecated Commands
Table 14-1. Deprecated Commands
Deprecated Command New Command
start rollback (volume
[flashcopyVolumeName | volumes
[flashcopyVolumeName1 ...
flashcopyVolumeNamen])
start (volume [flashcopyVolumeName |
volumes [flashcopyVolumeName1 ...
flashcopyVolumeNamen]) rollback
The order of the terms in the syntax is
changed to be consistent with other
commands.
Deprecated Parameters
Table 14-2. Deprecated Parameters
Old Syntax New Syntax
copyType=(online | offline) This parameter is removed from these
commands:
v recopy volumeCopy
v remove volumeCopy
v set volumeCopy
© Copyright IBM Corp. 2008, 2012 14-1
To Next Page
Loading...
Need help?
General