Show Enhanced Remote Mirroring volume candidates
This command returns information about the candidate volumes on a remote storage subsystem that you
can use as secondary volumes in a Enhanced Remote Mirroring configuration.
Note: In previous versions of this command the feature identifier was remoteMirror. This feature
identifier is no longer valid and is replaced by syncMirror.
Syntax
show syncMirror candidates primary="volumeName"
remoteStorageArrayName="storageArrayName"
Parameter
Parameter Description
primary The name of the local volume that you want for the
primary volume in the remote-mirrored pair. Enclose the
primary volume name in double quotation marks (" ").
remoteStorageArrayName The remote storage subsystem that contains possible
volumes for a secondary volume. If the remote storage
subsystem name has special characters, you must also
enclose the remote storage subsystem name in double
quotation marks (" ").
Minimum Firmware Level
5.40
Show Enhanced Remote Mirroring volume synchronization progress
This command returns the progress of data synchronization between the primary volume and the
secondary volume in a Synchronous Mirroring configuration. This command shows the progress as a
percentage of data synchronization that has been completed.
Note: In previous versions of this command the feature identifier was remoteMirror. This feature
identifier is no longer valid and is replaced by syncMirror.
Syntax
show syncMirror (localVolume ["volumeName"] |
localVolumes ["volumeName1" ... "volumeNameN"])
synchronizationProgress
Parameters
Parameter Description
localVolume or localVolumes The name of the primary volume of the remote mirrored
pair for which you want to check synchronization
progress. Enclose the primary volume name in double
quotation marks (" ") inside of square brackets ([ ]).
Chapter 3. Script Commands 3-279
To Next Page
Loading...
Need help?
General