Validate Storage Subsystem Security Key
This command validates the security key for a storage subsystem that has full disk encryption (FDE)
drives to make sure that the security key is not corrupt.
Syntax
validate storageSubsystem securityKey
file="fileName"
passPhrase="passPhraseString"
Parameters
Parameter Description
file The file path and the file name that has the security key.
Enclose file path and the file name in double quotation
marks (" "). For example: file="C:\Program
Files\CLI\sup\seckey.slk"
Important: The file name must have an extension of .slk.
passPhrase A character string that encrypts the security key so that you
can store the security key in an external file. Enclose the
pass phrase in double quotation marks (" ").
Notes
Your pass phrase must meet these criteria:
v The pass phrase must be between eight and 32 characters long.
v The pass phrase must contain at least one uppercase letter.
v The pass phrase must contain at least one lowercase letter.
v The pass phrase must contain at least one number.
v The pass phrase must contain at least one non-alphanumeric character, for example,<>@
Note: If your pass phrase does not meet these criteria, you will receive an error message.
Script Commands Listed by Function
subsystem Commands
“Create subsystem” on page 3-55
“Delete subsystem” on page 3-108
“Enable subsystem Security” on page 3-130
“Revive array” on page 3-168
“Set subsystem” on page 3-184
“Set subsystem Forced State” on page 3-186
“Show subsystem” on page 3-247
“Show subsystem Export Dependencies” on page 3-247
3-322 IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide
To Next Page
Loading...
Need help?
General