To Next Page

To Previous Page

Note: Within the subsystem, you cannot move logical drives that are associated with the premium

features from one storage subsystem to another storage subsystem.

Syntax

start array [arrayName] import

Parameter

Parameter Description

array The alphanumeric identifier of the array (including - and _)

that you want to import. Enclose the subsystem identifier in

square brackets ([ ]).

Notes

Higher-level logical drives that are specifically related to premium features (FlashCopy, Enhanced Remote

Mirroring, VolumeCopy, mapping, and persistent reservations) are removed as part of the import

operation.

The show subsystem importDependencies command must be run before the start subsystem import

command.

Start subsystem Locate

This command identifies the disk drives that are logically grouped together to form the specified

subsystem by flashing the indicator lights on the disk drives. (Use the stop subsystem locate command

to turn off the indicator lights on the disk drives.)

Syntax

start subsystem [subsystemNumber] locate

Parameter

Parameter Description

subsystem The alphanumeric identifier of the subsystem (including -

and _) for which you want to locate the disk drives that

belong to that subsystem. Enclose the subsystem identifier

in square brackets ([ ]).

Start Enhanced Global Mirroring synchronization

This command starts Enhanced Global Mirroring synchronization.

Syntax

start enhancedGlobalMirrorGroup ["enhancedGlobalMirrorGroupName"]

synchronize

3-284 IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide

IBM System Storage DS3000 User Manual

Questions and Answers: