Appendix A. Examples of information returned by the show
commands
This appendix provides examples of information that is returned by the show commands. These examples
show the type of information and the information detail. This information is useful in determining the
components, features, and identifiers that you might need when you configure or maintain a storage
subsystem.
Show storage subsystem
The show storageArray command returns information about the components and the features in a storage
subsystem. If you run the command with the profile parameter, the command returns information in the
form shown by this example. This information is the most detailed report that you can receive about the
storage subsystem. After you have configured a storage subsystem, save the configuration description to
a file as a reference. The show storageArray command returns information about the components and the
features in a storage subsystem. If you run the command with the profile parameter, the command
returns information in the form shown by this example. This information is the most detailed report that
you can receive about the storage subsystem. After you have configured a storage subsystem, save the
configuration description to a file as a reference.
© Copyright IBM Corp. 2008, 2012 A-1
To Next Page
Loading...
Need help?
General