drive expansion enclosure and the ID of the slot in which a drive resides. For a lowcapacity drive
expansion enclosure, an alternative method for identifying a location for a drive is to specify the ID of
the drive expansion enclosure, set the ID of the drawer to 0, and specify the ID of the slot in which a
drive resides.
Start Disk Drive Reconstruction
This command starts reconstructing a disk drive.
Syntax
start Drive [enclosureID1,drawerID1,slotID1 ... enclosureIDn,drawerIDn,slotIDn]
reconstruct
Parameter
Parameter Description
drive EnclosureID1,drawerID1,slotID1 ...
enclosureIDn,drawerIDn,slotIDn is for enclosures with
multiple disk drive drawers. For enclosures without disk
drive drawers, use enclosureID1,slotID1 ...
enclosureIDn,slotIDn instead. Enclosure ID values are 0 to 99.
Drawer ID values are 1 to 5. Slot ID values are 1 to 32.
Enclose values in square brackets ([ ]).
Notes
The drive parameter supports both high-capacity drive expansion enclosures and lowcapacity drive
expansion enclosures. A high-capacity drive expansion enclosure has drawers that hold the drives. The
drawers slide out of the drive expansion enclosure to provide access to the drives. A lowcapacity drive
expansion enclosure does not have drawers. For a high-capacity drive expansion enclosure, you must
specify the identifier (ID) of the drive expansion enclosure, the ID of the drawer, and the ID of the slot in
which a drive resides. For a lowcapacity drive expansion enclosure, you need only specify the ID of the
drive expansion enclosure and the ID of the slot in which a drive resides. For a lowcapacity drive
expansion enclosure, an alternative method for identifying a location for a drive is to specify the ID of
the drive expansion enclosure, set the ID of the drawer to 0, and specify the ID of the slot in which a
drive resides.
Start Enclosure Locate
This command locates an enclosure by turning on the indicator light. (Use the stop enclosure locate
command to turn off the indicator light for the enclosure.)
Syntax
start enclosure [enclosureID] locate
Parameter
Parameter Description
enclosure The enclosure that you want to locate. Enclosure ID values
are 0 to 99. Enclose the enclosure ID value in square brackets
([ ]).
Chapter 3. Script Commands 3-295
To Next Page
Loading...
Need help?
General