Syntax
show (allenhancedGlobalMirrorGroups | enhancedGlobalMirrorGroup
["enhancedGlobalMirrorGroupName"])
[summary]
Parameters
Parameter Description
allenhancedGlobalMirrorGroups Use this parameter if you want to display the properties
for all Enhanced Global Mirror Groups.
enhancedGlobalMirrorGroup Use this parameter to display the properties for an
Enhanced Global Mirror Group. Enclose the Enhanced
Global Mirror Group name in square brackets ([ ]). If the
Enhanced Global Mirror Group name has special
characters, you also must enclose the Enhanced Global
Mirror Group name in double quotation marks (" ")
inside square brackets. If the Enhanced Global Mirror
Group name consists only of numbers, such as "1002,"
you also must enclose the Enhanced Global Mirror
Group name in double quotation marks (" ") inside
square brackets.
summary Use this optional parameter to show a concise list of
information about the synchronization progress of one or
more Enhanced Global Mirror Groups.
Minimum Firmware Level
7.840
Show Enhanced Global Mirror Group synchronization progress
This command displays the progress of periodic synchronization of the Enhanced Global Mirror Group
between the local and remote storage array. This command returns the progress of data synchronization
on all of the mirrored pairs within the Enhanced Global Mirror Group. This command shows the
progress as a percentage of data synchronization that has been completed.
Note: There are two types of synchronization: initial synchronization and periodic synchronization. Initial
Enhanced Global Mirror Group synchronization progress is displayed in the Long Running Operations
dialog and by running the show storageArray longRunningOperations command.
Syntax
show enhancedGlobalMirrorGroup ["enhancedGlobalMirrorGroupName"]
[synchronizationProgress]
Chapter 3. Script Commands 3-249
To Next Page
Loading...
Need help?
General