Syntax
show cacheMemory controller [(a | b)] diagnosticStatus file="fileName"
Parameters
Parameter Description
controller The controller that has the cache memory on which you are
running the diagnostic tests. Valid controller identifiers are a
or b, where a is the controller in slot A, and b is the
controller in slot B. Enclose the controller identifier in square
brackets ([ ]).
file The name of the file that contains the result of the diagnostic
tests. Enclose the file name in double quotation marks (" ").
This command does not automatically append a file
extension to the file name. You must add an extension when
you enter the file name.
Show consistency group
This command returns information about one or more consistency groups.
Syntax
show (consistencyGroup [consistencyGroupName] |
consistencyGroups [consistencyGroupName1 ...
consistencyGroupNameN] |
allConsistencyGroups)
[(summary | schedule)]
Parameters
Parameter Description
consistencyGroup or consistencyGroups The name of the specific consistency group for which
you are retrieving information. You can enter more than
one consistency group name. Enclose the consistency
group name in square brackets ([ ]).
You can enter more than one Enhanced FlashCopy image
name or sequence number. Enclose all of the Enhanced
FlashCopy image names in one set of double quotation
marks (" ") inside square brackets ([ ]). Separate each
Enhanced FlashCopy image name with a white space.
allConsistencyGroups This setting returns information about all of the
consistency groups in the storage subsystem.
summary This setting returns a concise list of information about
the consistency groups.
schedul This parameter returns information about any schedules
for a consistency group.
Minimum Firmware Level
7.83
Chapter 3. Script Commands 3-251
To Next Page
Loading...
Need help?
General