IBM System Storage DS3000 User Manual

The DCS3700 and DCS3700 storage subsystem with Performance Module Controllers are part of the
DS3000 product series. Not all commands that are supported by DS3000 can be used in the DS3200,
DS3300, and DS3400 storage subsystems. Some commands are supported only with the DS3500, DCS3700,
and DCS3700 storage subsystem with Performance Module Controllers storage subsystems.
Commands with minimum controller firmware requirements are alphabetically listed below:
Activate Enhanced Remote Mirroring Feature
DS3000: 7.7x.xx.xx
DS4000: 6.1x.xx.xx
DS5000: 7.3x.xx.xx
Note:
v 7.10 adds RAID Level 6 capability
v 7.60 adds the drawerID user input, the driveMediaType parameter, and the drawerLossProtect
parameter.
v For version 7.60.xx.xx, you can change the repositoryDrive parameter to accommodate the
enclosures with internal disk drawers.
v 7.77 adds the T10 PI parameter.
Activate Host Port
DS3000: 7.35.xx.xx
DS4000: N/A
DS5000: 7.6x.xx.xx
Activate iSCSI Initiator
DS3000: 7.35.xx.xx
DS4000: N/A
DS5000: 7.6x.xx.xx
Activate Storage Subsystem Firmware
DS3000: 6.17.xx.xx
DS4000: 6.1x.xx.xx
DS5000: 7.3x.xx.xx
Add Member to Consistency Group
DS3000: 7.83.xx.xx and later
DS4000: N/A
DS5000: N/A
Autoconfigure Storage Subsystem
DS3000: 6.17.xx.xx
DS4000: 6.1x.xx.xx
DS5000: 7.3x.xx.xx
Note:
v 7.50.xx.xx adds securityType parameter.
v 7.77 adds the T10 PI parameter.
Autoconfigure Storage Subsystem Hot Spares
DS3000: 6.17.xx.xx
3-4 IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide

IBM System Storage DS3000 Specifications

General

Brand	IBM
Model	System Storage DS3000
Category	Storage
Language	English