Chapter 12. Examples of Information Returned by the Show
Commands
This chapter provides examples of information that is returned by the show commands. These examples
show the type of information and the information detail. This information is useful in determining the
components, features, and identifiers that you might need when you configure or maintain a storage
subsystem.
Show Storage Subsystem Command
The show storageSubsystem command returns information about the components and the features in a
storage subsystem. If you run the command with the profile parameter, the command returns
information in the form shown by this example. This information is the most detailed report that you can
receive about the storage subsystem. After you have configured a storage subsystem, save the
configuration description to a file as a reference.
PROFILE FOR STORAGE SUBSYSTEM: DS5300_middle (1/27/09 3:23:25 PM)
SUMMARY------------------------------
Number of controllers: 2
High performance tier controllers: Enabled
Number of subsystems: 5
RAID 6: Enabled
Total number of logical drives used: 10
Number of standard logical drives: 9
Number of access logical drives: 1
Total number of logical drives allowed: 2048
FlashCopy Logical Drives: Enabled
Number of flashcopies used: 0
Number of flashcopies allowed: 2
Number of flashcopies allowed per base logical drive: 2
Enhanced Remote Mirroring: Disabled/Deactivated
Number of mirrors used: 0
Number of mirrors allowed: 0
VolumeCopy: Disabled
Number of copies used: 0
Number of copies allowed: 0
Number of drives: 32
Mixed drive types: Enabled
Current drive type(s): Fibre (5), Fibre/FDE (21), Serial ATA (SATA) (6)
Total hot spare drives: 2
Standby: 2
In use: 0
© Copyright IBM Corp. 2008, 2012 12-1
To Next Page
Loading...
Need help?
General